Domestic Electrical Safety Tests; Ac Line Voltage Test - GE T2100 Service Manual

Domestic Electrical Safety Tests

AC Line Voltage Test

200 to 240 VAC, 50/60 Hz
Revision A
Installation: Domestic Electrical Safety Tests
This test verifies that the domestic wall outlet supplying power to the
equipment is properly wired. For international wiring tests, refer to the
internal standards agencies of that particular country.
Use a digital voltmeter set to measure at least 300 VAC to check the
voltages of the NEMA 6-20R AC wall outlet (U.S. domestic only, or
applicable international connection; dedicated circuit recommended). If
the measurements are significantly out of range, have a qualified
electrician repair the outlet. The voltage measurements should be:
200 to 240 nominal VAC between the two "hot" contacts.
HOT
NOTE
For proper and safe operation of the GE T2100 Treadmill, ensure the
power source is clean. See
page A-4 for more details.
GE T2100 Treadmill
2021403-031
❶
GROUND
"Power/Environmental Specifications"
HOT
015
on
3-5