Toshiba V Series Operation Manual page 15

Be Sure To Observe The Following
Observe the following to ensure the safety of the operator in using the equipment and
to keep it in normal operating condition.
1. Carefully read the Operation Manual before use.
2. Avoid installing or keeping the equipment at any of the places or in the environment
mentioned below.
(1) Very dusty place
(2) Place where corrosive gases (SO
(3) Place where the product may be exposed to vibration or shock
(4) Environment of low or high temperature deviating from the conditions for installation
specified herein.
(5) Very humid place
3. If the ambient temperature or the internal temperature of the equipment has arisen too
high, or if the equipment has developed a fault, stop using it, switch power off, and
contact the nearest Toshiba service station.
4. Do not open the case of the equipment while it is in operation except when setting the
switches.
5. Do not attempt to modify the equipment.
6. Take care not to drop the module during transit.
7. FL311 and FL312 comply to different FL-net(OPCN-2) protocols as shown below.
Therefore, FL311 and FL312 cannot run on the same network. Also note the protocol
version when connecting to other manufacturer's FL-net compliant modules.
FL311
FL312
If FL312 is included in a protocol version 1.00 network, it will fail as follows.
Node status
Down information
LED
If FL311 is included in a protocol version 2.00 network, it will not fail but it cannot
link to the network.
LED
6F8C1067
FL-net (OPCN-2) protocol version 1.00 compliant
FL-net (OPCN-2) protocol version 2.00 compliant
DOWN bit ON
0800h
RUN
LNK
TX
RX
PER
RUN
LNK
TX
RX
PER
, H S, etc.) are generated
2 2
ON
OFF
OFF
ON or Flashing
OFF
ON
Flash
Flash
ON or Flashing
OFF
xiii