Toro Reelmaster 7000-D Service Manual page 183

7. Inspect reel insert splines for wear. Replace if neces-
sary (see Reel Assembly Removal and Installation in
Chapter 9 - DPA Cutting Units in this manual).
8. Place protective plastic cap (see Special Tools in this
chapter) into the hole in the cutting unit side plate to pre-
vent debris entry into reel bearing area.
9. If hydraulic fittings are to be removed from reel mo-
tor, mark fitting orientation to allow correct assembly.
Remove fittings from motor and discard O- rings.
Installation (Fig. 69)
1. If fittings were removed from reel motor, lubricate
and place new O- rings onto fittings. Install fittings into
motor ports using marks made during the removal pro-
cess to properly orientate fittings. Tighten fittings (see
Hydraulic Fitting Installation in this chapter).
2. Remove cover from cutting unit opening.
3. Coat spline shaft of the reel motor with No. 2 multi-
purpose lithium base grease.
4. Oil the reel motor O-ring and install it onto the motor
flange.
5. Install the cap screws for the reel drive motor into the
cutting unit side plate and leave approximately 1/2 inch
(12.7 mm) of threads exposed on each screw.
6. Rotate the motor clockwise so the motor flanges
clear the cap screws in the cutting unit side plates. Align
reel motor shaft splines with cutting reel insert splines.
Slide motor shaft into reel insert.
Reelmaster 7000- D
7. Rotate the motor counter- clockwise until the motor
flanges are encircling the cap screws. Tighten two (2)
cap screws to secure reel motor to cutting unit (Fig. 70).
8. Remove caps or plugs from hydraulic fittings and
hoses. Connect hydraulic hoses to reel motor (see Hy-
draulic Hose and Tube Installation in this chapter).
9. After assembly is completed, verify that hydraulic
hoses and fittings are not contacted by any moving com-
ponents.
10.Check oil level in hydraulic reservoir and add correct
oil if necessary.
11. Follow hydraulic system start- up procedures (see
Charge Hydraulic System in this chapter).
2
1. Cap screw
Page 5 - 113
1
Figure 70
2. Hydraulic reel motor
Hydraulic System