Sony CCP-8000 Installation Manual page 33

<TEST terminal>
E1 (A-2) : GND pin
Used for GND when measuring each check terminal.
TP8 (A-2) : + + + + + 12 V check pin
+12 V measuring terminal.
<LED on the CPU DR module> : Main CPU
D10 (green) (A-1) : RUN status LED
RUN status indication.
Lit when the CPU-DR module starts operating.
D12 (green) (A-4) : CD (Card Detect) status LED
Lit when the CPU-DR module is inserted correctly to the
parent board.
D13 (green) (A-1) : +2.5 V
Indicates the statue of the +2.5 V power that is generated
by the VCC (CORE) and supplied to the CPU-DR module.
Lit while the specified power is turned on.
D14, D15, D16, D17 (A-3) (green) : STATUS1 to
STATUS4 status LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
D18 (green) (A-4) : +3.3 V
Indicates the status of the VCC (I/O) power that is supplied
to the CPU-DR module.
Lit while the specified power is turned on.
D19 (green) (A-4) : CORE status LED
Indicates the status of the VCC (CORE) power that is
supplied to the CPU-DR module.
Lit while the specified power is turned on.
<Switch on the CPU DR module> : Main CPU
SW1 (A-2) : RESET switch
Pressing this switch resets the CPU-DR module.
n
In some machines in which the CPU-DR module is
installed, the system reset may be activated.
SW2 (A-2) : MODE switch
8-pin DIP switch
Used only for production in the assembly factory. All
switches are set to OFF for normal operation.
CCP-8000 IM
1-10. Checks on Completion of Installation
<LED on the CPU DK module> (COM0) (COM1)
DI1 (green) (B-5) : CD (Card Detect) status LED
Lit when the CPU-DK module is inserted correctly to the
parent board.
DI2 (green) (F-3) : RUN status LED
Lit when the CPU-DK module starts operating.
DI3 (F-3) (green) : STATUS4 LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
DI6 (F-3) (green) : STATUS3 LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
DI7 (F-3) (green) : STATUS2 LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
DI8 (F-4) (green) : STATUS1 LED
Used for maintenance purpose. Only the STATUS1 LED is
lit in normal operation.
DI4 (green) (B-5) : + + + + + 3.3 V
Indicates the status of the VCC (CORE) and VCC (I/O)
powers that are supplied to the CPU-DK module.
<Switch on the CPU DK module> (COM0) (COM1)
SW1 (D-5) : RESET switch
Pressing this switch resets the CPU-DK module.
n
In some machines in which the CPU-DK module is
installed, the system reset may be activated.
SW2 (C-5) : MODE switch
8-pin DIP switch
Used only for production in the assembly factory. All
switches are set to OFF for normal operation.
Default setting when shipped from the factory is all OFF.
1-25