Huawei FusionModule2000 Installation Manual page 156

FusionModule2000 Smart Modular Data Center
Installation Guide
3.
4.
Step 5 Install the door box.



1.
2.
3.
Issue 02 (2018-03-31)
Figure 10-59 Door panel tilting down
If door panels mismatch, loosen screws between the posts and cabinets and insert
washers to make the door panels on the same plane when they are closed, as shown by (3)
in Figure 10-54. After adjustment, tighten all screws.
Tighten the screws connecting the door posts and the skylight connective plates.
Two types of door boxes are available: 1100 mm long and 1200 mm long. Door boxes are packed
with revolving doors.
When installing the door boxes, pay attention to the left, right, and length labels on the door boxes.
The two types of door boxes can be installed in a similar way. The following installation procedure
uses the 1200 mm long door box as an example.
Put the door box hanger on the cabinet, insert the tongue of the door box fastener into the
gap between the cabinet frame and the top panel, and secure them using six M5 screws,
as shown by Figure 10-60.
Mount the door box on the door box hanging kit, push the door box rightwards until it
touches the door post, and insert the two tongues on the right side into the stop holes on
the door post, as shown by (1) in
Secure the door box to the door box hanging kit using three M5 screws, as shown by (2)
in Figure 10-61.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Installing the Aisle Containment
Figure 10-61.
147