Siemens SINAMICS S120 Combi Equipment Manual page 200

Electrically connecting Motor Modules and DC link components
8.4 Connecting an additional component
3. Install the lower and upper DC link busbars.
4. Install the 24 V connector (accessories pack of the component to be connected).
Figure 8-4
5. Close the protective covers of both components.
200
Install the lower DC link busbar
Release the screws.
•
Turn over the DC link bridge.
•
Observe the following sequence when
•
screwing into place.
Screwdriver Torx T20 or slotted 1.2 x 6
Tightening torque 1.8 Nm
Motor Modules with 24 V connector installed
Install the upper DC link busbar
Release the screws.
•
Turn over the DC link bridge.
•
Observe the following sequence when
•
screwing into place.
Manual, (GH9), 07/2016, 6SL3097-4AV00-0BP5
SINAMICS S120 Combi