3. Install the lower and upper DC link busbars.
4. Install the 24 V connector (accessories pack of the component to be connected).
Figure 8-2
5. Close the protective cover of the connected component.
6. Mount the front plate on the S120 Combi.
SINAMICS S120 Combi
Manual, (GH9), 07/2016, 6SL3097-4AV00-0BP5
Install the lower DC link busbar
Release the screws.
•
Turn over the DC link bridge.
•
Observe the following sequence when
•
screwing into place.
Screwdriver
Torx T20 or slotted 1.2 x 6
Tightening torque
1.8 Nm
S120 Combi and Motor Module with installed 24 V connector
Electrically connecting Motor Modules and DC link components
8.3 Connection of DC link busbars and 24 V busbars
Install the upper DC link busbar
Release the screws.
•
Turn over the DC link bridge.
•
Observe the following sequence when
•
screwing into place.
197