Fundamentals
2.4 Tool change
2.4.3
Behavior with faulty T programming
The behavior with faulty T programming depends on the configuration of the machine:
MD22562 TOOL_CHANGE_ERROR_MODE
Bit
7
66
Value
Meaning
0
Basic setting!
With the T programming, a check is made immediately as to whether the NC recogni‐
zes the T number. If not, an alarm is triggered.
1
The programmed T number will only be checked following D selection. If the NC does
not recognize the tool number, an alarm is issued during D selection.
This response is desirable if, for example, tool programming is also intended to achieve
positioning and the tool data is not necessarily available (circular magazine).
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
NC programming