Fundamentals
2.9 Motion commands
2.9.9.3
Contour definitions: Two straight lines
Note
In the following description it is assumed that:
● G18 is active (⇒ active working plane is the Z/X plane).
(However, the programming of contour definitions is also possible without restrictions with
G17 or G19.)
● The following identifiers have been defined for angle, radius and chamfer:
– ANG (angle)
– RND (radius)
– CHR (chamfer)
The end point of the first straight line can be programmed by specifying the Cartesian
coordinates or by specifying the angle of the two straight lines. The end point of the second
straight line must always be programmed with Cartesian coordinates. The intersection of the
two straight lines can be designed as a corner, curve or chamfer.
ANG1:
ANG2:
X1, Z1:
X2, Z2:
X3, Z3:
Syntax
Programming of the end point of the first straight line by specifying the angle
● Corner as transition between the straight lines:
214
Angle of the first straight line
Angle of the second straight line
Start coordinates of the first straight line
End point coordinates of the first straight line or
start coordinates of the second straight line
End point coordinates of the second straight line
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
NC programming