Bosch VLE 21 Series Repair Instructions page 43

8. Manual release mechanism
8.1 Fitting manual release mechanism
Contents Fitting manual release mechanism
Applicability VLE 2130, VLE 2130 F, VLE 2130 EL,
VLE 2140 EL
Special tools and Manual release mechanism
other items (special accessory)
Order no. 1 692 872 149
1. Remove the securing strap (Fig. 19, Pos. 3) to
expose the lifting carriage opening.
2. Guide the release lever (Fig. 19, Pos. 1) from the
front through the front of the lifting carriage.
3. Position the channel section of the lever on the
upper threaded rod (Fig. 19, Pos. 2) and then tilt the
lever to the rear.
Fig. 19: Inserting release lever
1 Release lever
2 Upper threaded rod
3 Securing strap
4. Screw (2x) the knob (Fig. 20, Pos. 5) onto the guide
rod (Fig. 20, Pos. 4) (2x).
5. Screw the guide rod into the tapped hole of the
release lever (Fig. 19, Pos. 1) to a depth of 7 mm.
6. Check operation of the manual release mechanism.
7. Fasten the securing strap (Fig. 19, Pos. 3) at the
bottom with a fastening pin.
Robert Bosch GmbH
Manual release mechanism | VLE 21xx | 43
Fig. 20: Fitting manual release mechanism (view from above)
4 Guide rod
5 Knob
en
|
1 689 975 224 2013-11-06