Installation On The Tower - Huawei AISU User Manual

AISU
User Manual

3.4.2 Installation on the Tower

Installing the Bracket
Step 1 Install one end of the bracket into the antenna top cover and then tighten the 1# screw so that
the hook is located between the antenna top cover and the antenna radome.
Step 2 Move the sliding pole of the bracket so that the other end of the bracket is inserted into the
antenna top cover. Then, tighten the 2# screw.
Step 3 Tighten the 3# screw.
Issue 02 (2017-06-12)
 The bracket must be aligned with the edge of the antenna top cover.
 The hook on the bracket must be completely located in the gap between the antenna top cover and
the antenna radome, and the bottom of the hook must be in good contact with the lower edge of the
antenna top cover. Use a wrench to knock the position shown in the follow figure so that the hook is
installed properly.
 After the bracket is installed, confirm that the bracket is secured properly.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Installation and Replacement
12