Enter Installer Mode - LG MULTI V HYDRO KIT ARNH963K2A4 Installation Manual

PRE-COMMISSIONING
Hydro Kit DIP Switch Settings / Enter Installer Mode
Table 32: Hydro Kit DIP Switch Group 3 Settings and Descriptions.
Description
Sensor Selection
Antifreeze Operation Mode
Do not operate the Hydro Kit unit in Antifreeze Operation Mode until after the proper amount of antifreeze is added
to the water circuit. The product will freeze and burst, causing physical injury and / or death.
Do not operate the Hydro Kit unit in Antifreeze Operation Mode until after the proper amount of antifreeze is added
to the water circuit. The product will freeze and burst, causing product damage.
How to Enter Installer Setting Mode
The Installer Setup Mode must be used to set the functionality of the remote controller, and to customize the Hydro Kit settings.
unit.
1. On the menu screen, press the < Left / > Right buttons to select the setting category.
2.
3. Input the password and press the OK button to access the installer setting list.
Installer Setting Mode Password
1001.
depending on the product function. Menu name could also be different.
86
DIP Switch Group 3 Settings
1 2 3 4
X
X
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG Life's Good" is a registered trademark of LG Corp.
Function
Air Sensor in Hydro Kit (RS3)
Air Sensor (ZRTBS01)
Not Use (Connect Short Key*)
Use (Disconnect Short Key*)
Figure 103: Entering Installer Setting Mode.
OK
Default
Figure 104: Short Key*.
y
CN_FLOW2
OK