LG MULTI V HYDRO KIT ARNH963K2A4 Installation Manual page 61

5. Turn power off at the circuit breaker.
6. Open the Hydro Kit front panel / control box cover.
7. Route the Room Temperature Sensor cable through an opening in the bottom of the Hydro Kit.
the power input cable.
8. Insert the connector of the remote temperature button sensor cable into the CN-ROOM connector on the PCB.
9. Use a cable tie or other method to secure the remote temperature button sensor cable inside the Hydro Kit.
cable.
10. Reinstall the Hydro Kit front panel / control box cover, and apply power.
11. See the Controller and Pre-Commission sections for instructions on how to properly set the function code. For more information on the
remote temperature sensor, see the submittal and the installation manual on www.lghvac.com.
Do not cut the sensor cable. If the cable is longer than necessary, coil and secure excess cable.
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG Life's Good" is a registered trademark of LG Corp.
Connecting Optional LG Hydro Kit Accessories
WIRING
Do not use the same access hole as
Do not allow strain on the
61