Introduction
Editing Pattern
Editing Pattern
Figure 15
Shows which memory location
can actually be edited
NOTE:
Access the pattern entry (PATTERN) menu screen by pressing the
|PATTERN|
when data streams in Pattern operating mode will be set up.
NOTE:
54
PATTERN Screen
Bit-editing Window
Make sure that in the
|MODE/TRG| screen the pattern operating mode
is selected. Please refer to "Available Operating/Trigger Modes" on page
47.
softkey. This screen has to be accessed for pattern entry
A signal with a number of pulses followed by a pause is what we
would call a burst signal. Such burst signals are recommended to
be set up in the burst mode, as this is done more quickly and easier
as it would be in the pattern mode.
Introduction
Set the pattern length here
HP 81110/04A Quick Start