Table of Contents
Advertisement
If an optional RS-530 or RS-232 module is installed, the
following configuration changes must be made before the module(s)
become available on the front panel menu. Use the following
entry in the PhysicalTable section in place of either the
Group 4 (port 4) or Group 5 (port 5) entry, depending on which
slot the module is installed in.
module is installed and setup for 9600 bps async.
can then be configured as needed from the front panel.
Under "PhysicalTable", "Group 4" or "Group 5":
OM
1000.
SN
M
OM-1000 logical port assigments and there associated service
name must be specified in this file.
the OM-1000 itself, but is passed along intact to the ACC-4000D
upon registration.
must be recognizable by the ACC-4000D.
OM
1000.
SV
C
Network services and their ethernet port and protocol are
listed here.
device port and protocol (usually 5167/tcp).
header for format.
8 0 0 0 1 9600 0 0 0
#Group 3
3 0 0 0 0 0 0 0 0 0 0 0 0
- - -
a b c
where: (use with Group 3 (ethernet) ONLY!)
-----------------------
a = multicast rcv MAC upper byte (in decimal)
b = multicast rcv MAC middle byte (in decimal)
c = multicast rcv MAC lower byte (in decimal)
example:
256 24064 543
--- ----- ---
a
De
fault
Entry (no module installed
1 0 0 0 0 0 0 0 0 0 0 0 0
For
RS-
232 cards:
6 0 0 0 1 9600 0 0 0 0 0 0 0
For
RS-
530 cards:
7 0 0 0 1 9600 0 0 0 0 0 0 0
See file header for format.
The OM-1000 uses this file to select the control
Initialization Information
0 0 0 0
(=01:00:5E:00:02:1F)
----- ----- -----
b
c
(=
a
b
This tells the software the
The module
):
This is not used within
Service names
See the file
OM 1000 Installation and Operation Manual
C-11
c
)
Advertisement
Table of Contents
