Table of Contents
Advertisement
4-4
Setup and Operation
To change the factory default settings, enter the changes at the front panel (or edit the
configuration data in the config.ini file). This section provides menu procedures to set up
the OM 1000 from the front panel. Some of the menu procedures are supplemental, as they do
not directly alter operating settings of the OM 1000; however, proficiency with these menus is
also required:
MAIN Menu
ADMIN Menu
−
ADMIN Menu⎯Saving and Implementing Changes
−
ADMIN Menu⎯Rebooting the OM 1000
−
ADMIN Menu⎯Purging the OM 1000 Software
INTFC Menu⎯Modifying the Physical Port Default Settings
−
INTFC 1 Menu⎯Viewing Port 1 (RS-232 Console Port) Settings
−
INTFC 2 Menu⎯Setting Up Port 2 (RS-530/RS-232)
−
INTFC 3 Menu⎯Setting Up Port 3 (Ethernet)
−
INTFC 4/INTFC 5 Menu⎯Setting Up Ports 4 and 5 (Optional RS-530/RS-232)
−
INTFC 6 Menu⎯Setting Up Port 6 (RF Modulator)
Spectrum Analyzer Procedure⎯Setting the Modulator Output Signal Level in
Operate Mode
Spectrum Analyzer Procedure⎯Setting the Modulator Output Signal Level in 2T
Test Mode
−
INTFC 7 Menu⎯Viewing the Internal MPEG Message Generator Port
PORT Menu⎯Setting Up Logical Ports
−
PORT Menu⎯Setting PID Maps (Input Ports Only)
−
PORT Menu⎯Setting PID Maps for Ethernet Input Ports
−
PORT Menu⎯Setting PID Maps for Non-Ethernet Input Ports
−
PORT Menu⎯Setting Logical Non-Ethernet Input Ports
−
PORT Menu⎯Setting Receive Multicast IP Addresses (Logical Ethernet Input Ports
Only)
−
PORT Menu⎯Setting Up Logical Ethernet Output Ports
NET Menu⎯Setting UP the Network
−
NET Menu⎯Setting Up OAM&P
−
NET Menu⎯Setting Up the CTRL (Control) Menu Options
−
NET Menu⎯Setting Up SNMP
ID Menu⎯Displaying Unit Data
−
ID Menu⎯UNIT Menu Options
−
ID Menu⎯SW (Software) Menu Options
−
ID Menu⎯LOC (Location) Menu Options
OM 1000 Installation and Operation Manual
Advertisement
Table of Contents
