Washing The Machine - Toro ProPass 200 Operator's Manual

track outside the grooves. To track the belt, do the
following:
1. Determine which side the belt is tracking
towards.
2. Remove the safety covers from both front
corners.
3. On the side the belt is tracking towards, hold the
end of the tensioner rod stationary, then loosen
the locking nut and tighten the adjuster nut by 2
flats of the nut (Figure
4. Tighten both locking nuts and turn on the
conveyor belt.
5. Check the tracking movement. Repeat the
above steps until the belt tracks back to the
correct position.
Important:
Be patient! Do not over-tension
the belt.
6. Install both of the safety covers.
55).

Washing the Machine

Salts, road tar, tree sap, fertilizers, or chemicals may
damage the painted finish of the machine. Wash off
these deposits as soon as possible with detergent and
water. Additional cleaners or solvents may be needed,
but ensure that they are safe for painted surfaces.
WARNING
Flammable fluids and cleaners with toxic
vapors are hazardous to your health.
Do not use flammable fluids or cleaners with
toxic vapors. Follow the manufacturer's
recommendations.
Important:
Do not use a high-pressure washer.
This can remove paint, safety decals, and grease,
and can also damage components.
1. Remove the option before cleaning and wash
it separately.
2. Remove the handheld remote.
3. Wash the body of the machine with warm water
and a mild detergent
4. Completely rinse off the detergent residue with
clean water before it dries.
5. Remove the belt cleaning scraper assembly
from the rear of the machine
1. Belt cleaning scraper assembly
6. Raise the front of the machine as high as
necessary.
7. If you have a truck-mounted machine, use the
lift cylinder on the tow vehicle. (See the tow
vehicle's owner's manual.)
8. If you have a tow-behind or Truckster direct
connect chassis, use the jack stand on the
chassis.
41
(Figure 56).
Figure 56
g013355