Preparing The Machine For Operation - Toro ProPass 200 Operator's Manual

Preparing the Machine for
Operation
The machine features a unique color-coded operation system that takes the guess-work out of setting up your
machine. Simply choose the spread, identify the color, and then adjust each setting to match that color to
get a perfect spread every time.
Choosing the Spread
Choose the spread by reading the main operation decal found on the tailgate of the machine
1. Light spread spinner adjustment settings
2. Heavy spread spinner adjustment settings
This decal shows the range of spreads available and classifies them by color
a different rate of application from Ultra-Light through Ultra-Heavy. The spread density is indicated by the
shaded ovals (light through heavy). The approximate width is also indicated
Checking the Blades
Note:
The machine is shipped with the spinner
blades in P B.
OSITION
The lighter spreads (blue panel) remind you to ensure
that the spinner blades are in P
Figure 30
When the blades are in P
(closest to the center of the disc) are tight to the
blade wall and the outside bolts (closest to the
edge of the disc) are away from the blade wall.
This is critical as this position is engineered to give
the optimum spread and distribution at high speeds
and low sand volume.
A (Figure
OSITION
A, the inside bolts
OSITION
Figure 28
3. Warning—slide adjustment and tailgate adjustment
Figure 29
For heavier settings (gold panel) the blades should be
in P B to provide the best distribution at higher
OSITION
volumes and slower disc speeds
30).
g013716
When the blades are in P
(closest to the center of the disc) are away from
the blade wall and the outside bolts (closest to the
edge of the disc) are tight to the blade wall.
Important:
Incorrect blade position is a common
reason that spread patterns fail.
20
(Figure
(Figure 29). Each color represents
(Figure 31).
Figure 31
B, the inside bolts
OSITION
28).
decal119-6814
g013715
g013717