Maintenance; Pre-Maintenance Safety; Lubrication - Toro ProPass 200 Operator's Manual

Maintenance

Note:
To obtain an electrical schematic or a hydraulic
schematic for your machine, visit www.Toro.com.
WARNING
Working on the machine before disconnecting
all power sources could result in serious
personal injury or death.
Disconnect all power sources to the machine
before doing maintenance work.

Pre-Maintenance Safety

•
Before servicing or making adjustments to the
machine, stop the machine, shut off the engine,
engage the parking brake, remove the key, and
wait for all moving parts to stop.
•
Perform only those maintenance instructions
described in this manual. If major repairs are
ever needed or assistance is desired, contact an
authorized Toro distributor.
•
Ensure that the machine is in safe operating
condition by keeping nuts, bolts, and screws tight.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Do not check or adjust the chain tension when the
tractor engine is running.
•
Carefully release pressure from components with
stored energy.
•
Support the machine with blocks or storage stands
when working beneath it. Never rely on the
tractor's hydraulics to support the machine.
•
Check the tine mounting bolts daily to be sure that
they are tightened to specification.
•
Ensure that all guards are installed and the hood
is secured shut after maintaining or adjusting the
machine.

Lubrication

Lubricating the Machine
•
Use an all-purpose automotive grease.
•
Lubricate regularly, after 25 hours of normal
operation.
•
Lubricate daily when operating in extremely dusty
and dirty conditions.
•
Lubricate all bearings, bushings, and chains.
Several grease fittings are located on the machine
and the tow-behind chassis
Figure 54).
1. Clean the grease fittings.
2. Pump the grease into the bearings and the
bushings.
3. Clean off the excess grease.
4. Clean and pack the wheel bearings every year
or every 300 hours of operation
1. Grease fitting on Base Model (1 at left front, 1 at right front)
1. Grease fitting on Base Model (1 at left rear, 1 at right rear)
38
(Figure 52, Figure 53
Figure 52
Figure 53
and
g013352
g013353