Advertisement
5. Open the board level in the direction of arrow A.
Remove the board-to-board connector that is connect-
ed to the MB-898 board.
6. Pull up the DVP board assembly in the direction of
arrow B by 15 mm. Then align the protrusion of the
board holder (F) with the dent of the DVP board
assembly.
B
Board lever
A
Protrusion
of the
board
holder (F)
Dent of the
DVP board
assembly
7. Remove the DVP board assembly by slanting it to the
front.
HKDW-704
Board lever
DVP board assembly
A
Board-to-board
connectors
MB-898 board
DVP board assembly
1-7. Removing and Reinstalling the DVP Board Assembly
Reinstallation
1. Raise the board lever to its upright position.
2. Insert the DVP board assembly in a slant angle until
the projection of the PC board holder (F) meets the
recess of the DVP board assembly. At the above angle,
raise in the right angle and insert it.
3. When shaft of the board lever enters into the chassis,
slant the board lever and push down the board from its
top until it is firmly inserted to the board-to-board
connector on the MB-898 board.
4. Reinstall it by reversing the steps of removal.
HDW-750/750P/750CE/730 only
n
When routing the coaxial cable, route it through the three
hooks of the PC board holder (R), the projections of the
SDI shield plate and the clamp so that it does not protrude
out exceeding the board lever.
Clamp
Projection of
the SDI shield plate
Coaxial cable
(WHT)
Serial No.10001 through 10119
Serial No.70001 through 70208
Coaxial cable
(WHT)
Board lever
PC board holder (R)
Hooks
Board lever
Projections of
the SDI shield plate
1-7 (E)
Advertisement
