Advertisement
1-4. Installation Procedure
Outline of installing the HKDW-704 to the HDW-750/750P/750CE/730 and the MSW-900/900P is listed
as follows. For the details of the installation work, refer to the respective sections.
Installation procedure
1. Confirming that the UMID SET display appears.
2. Removing the viewfinder
3. Removing the inside panel assembly
4. Removing the DCP board assembly
5. Removing the DVP board assembly
6. Removing the handle assembly
7. Installing the GPS-SS harness
8. Installing the GPS module
9. Reinstalling the DVP board assembly
10. Reinstalling the DCP board assembly
11. Reinstalling the Inside panel assembly
12. Reinstalling the viewfinder
13. Reinstalling the GPS antenna
14. Operation check
1 Turn on the power of the main unit once. Wait until
the system becomes operable. Then turn the power
back off. (The reboot is required to recognize the GPS
module installed.)
2 Turn on the power again and confirm that the GPS
SET UP display appears and the time indication
appears in the REAL item on the GPS INFORMA-
TION display, with the use of the OPERATION menu
of the main unit.
n
This manual is described on the premise of installing the HKDW-704 in the HDW-750/750P/750CE/730.
When the HKDW-704 is going to be installed in the MSW-900/900P, substitute the board names of the
HDW-750/750P/750CE/730 with the corresponding board names of the MSW-900/900P as shown below.
HDW-750/750P/750CE/730
DVP-18
DCP-28
FP-121
HKDW-704
Section describing the detailed procedure
1-2. Confirming Display before Installation and Starting to
"5-2. Adjusting the Viewfinder " of Operation Manual of the
main unit.
1-5. Removing and Reinstalling the Inside Panel Assembly
1-6. Removing and Reinstalling the DCP Board Assembly
1-7. Removing and Reinstalling the DVP Board Assembly
1-8. Removing and Reinstalling the Handle Assembly
1-9. Installing the GPS-SS Harness
1-10. Wiring Cables to the Handle Assembly
1-11. Installing the GPS Module
1-7. Removing and Reinstalling the DVP Board Assembly
1-6. Removing and Reinstalling the DCP Board Assembly
1-5. Removing and Reinstalling the Inside Panel Assembly
"5-2. Adjusting the Viewfinder " of Operation Manual of the
main unit.
1-12. Installing the GPS Antenna
(Refer to the HKDW-704 Operation Manual.)
. Setting
. To display the GPS INFORMATION screen.
MSW-900/900P
→
DVP-20
→
DCP-35
→
FP-121A
Use
1-4. Installation Procedure
1-3 (E)
Advertisement
