The Power Menu - Siemens SIMATIC Field PG P4 Manual

5.5

The Power Menu

This menu has the following structure:
Fig. 5-12
The operating system controls the power management of the Field PG P4 via
ACPI (Advanced Configuration and Power Interface). The BIOS power
management functions can only be used with non-ACPI operating systems.
Power Savings
Hard Disk Timeout
Resume On Time
Resume Time
Resume On Modem
Ring
SIMATIC Field PG P4 Manual
A5E00180080-04
PhoenixBIOS Setup Utility
Main Advanced Security
[Disabled]
Power Savings:
Hard Disk Timeout: [Disabled]
Resume On Time [On]
Resume Time: [00.00.00]
Resume On Modem Ring: [Off]
After Power Failure: [Stay Off]
Speed Step Mode [Recommended]
Help Select Item
F1
ESC Exit Select Menu
"Power" Menu
[Disabled]
[Enabled]
[Disabled]
[10, 15, 30, 45]
[1, 2, 4, 6, 8, 10, 15] Minutes after the last hard disk access
[On]
[Off]
Configuring the SIMATIC Field PG P4
Power Boot Version
Item Specific Help
[Enabled] [Disabled]
Switch on/off Power
Savings to conserves
system power.
+ / – Change Values F9
Enter Select Sub-Menu F10
Power management is only controlled via
ACPI.
The power-saving functions are set
The hard disk does not shut down.
Seconds or
The next time it is accessed, the hard disk
starts spinning again after a brief delay.
If this function is enabled the
programming device is automatically
switched on at the preset time.
'Off' means this function is disabled.
Time for automatic restart
Enabled wakes the system up when an
incoming call is detected on your modem.
Exit
Setup Defaults
Save and Exit
5-17