Installing Drivers And Software; Installing The Recovery Cd For Microsoft Windows Nt - Siemens SIMATIC Field PG P4 Manual

Reinstallation of the Software
Creating an Extended FAT 32 Partition
In order to create an extended partition you have to boot from the Recovery CD as
described above in steps 1 to 4.
Create an extended DOS partition for the rest of the disk space.
Under Windows 2000/XP, the FAT 32 file system can be changed to a NTFS file
system with the "Format" function.
8.3

Installing Drivers and Software

Installieren the drivers and software from the supplied DVD "Backup PG". Proceed
as follows:
1. Insert the DVD
2. Acrobat Reader must be installed
3. Navigate through the driver list to ../Drivers/FieldPG.pdf
4. Install the desired driver according to the Driver List.
8.4

Installing the Recovery CD for Microsoft Windows NT

This CD contains encoded data which can only be transferred onto a
SIEMENS SIMATIC programming device.
Data transfer is carried out with the OEMSETUP.EXE program on the CD-ROM or,
after booting, from the CD-ROM with the Recovery function.
After transferring the required data to the hard disk, the operating system can be
installed using the Windows NT setup program.
Windows NT Installation Sequence
If a Windows operating system is already installed or if the PC has been started
with a user created bootdisk, the transfer of the data takes place using the
program OEMSETUP.EXE. To do this, start the program OEMSETUP.EXE on the
recovery CD and continue the sequence as of point 5.
If there is no operating system installed, then please do the following:
1. Insert the Recovery CD into your CD-ROM drive and start the device.
2. To boot from the Recovery CD, press the ESC key when the BIOS message:
Press <F2> to enter Setup
is displayed. On the completion of initialization, a "Boot Menu" appears.
3. Select the "CD-ROM Drive" with the cursor.
4. When "Microsoft Windows 98-Startup Menu" is displayed, select
"1. Boot for CD-Recovery".
8-6
SIMATIC Field PG P4 Manual
A5E00180080-04