Siemens TC37 Module At Command Reference page 8

AT Command Set
6.2 144ff
6.3 146
6.7 152
6.13 157
6.17 161
6.25 166
6.20, 6.22, 163ff
6.24 – 6.28
6.37 177
6.38 178
7.1.2 183f
7.1.4 187
7.1.5 187
7.1.11 191
7.4 198
7.4.1 200
7.3 196
"AT Command Set" Version TC3x-ATC-01-V03.00=> TC3x5-ATC-01-03.10
Chapter Page
1.4.2 12
2.13 25
2.37 35
2.20 27
2.26 30
2.46 41
2.46.1 42
3 43
TC3X_ATC_01_V04.00
AT^MONI Examples on page 144 updated.
<chann> and <rs> explained in greater detail
References for 3GPP TS 05.05 and 05.08 added
Frequency hopping will now be indicated with "h"
(instead of the previously used "0".
Notes modified: If during a connection the radio cell is
changed, the parameters PWR and RXLev of the
'Serving Cell' part will not be updated.
Statement regarding RING line revised.
Statement regarding different values of identical cell
monitoring
AT^MONP and AT^SMONC) added.
At^MONP <chann> and <rs> explained in greater detail
Notes modified: During a connection new neighbour
cells can be added, but their parameters C1 and C2
will be updated after the call.
Statement regarding RING line revised.
AT^SCKS Notes regarding empty SIM card tray corrected.
AT^SLCK New <class> parameters added.
AT^SMONC New AT command: Cell monitoring
AT^SNFPT New AT command: Switch on / off Call Progress tones
AT^SNF... All Chapters revised.
AT^SSCONF New AT command: Configuring recipient address
parameters in SMS result codes and in +CDS URCs.
AT^SSDA New AT command: Set display availability
CMS errors List of codes revised: Deleted unnecessary codes.
Note and example added: Mapping of CME and CMS
errors if SIM PIN authentication has not been done.
Result codes "Connect 14400/RLP" added.
Location ID for List of codes revised: Deleted unnecessary codes.
AT+CEER
Release cause Notification 300 and note regarding Location ID
for call control added.
*# codes Abbreviations explained in greater detail.
Further examples added.
AT+VTS Added to List of PIN1 independent AT commands
AT command What is new
Any command Maximum length of command line buffer added.
AT+IPR To be used standalone.
ATI[value] Only value 9 supported
AT&S <value>2 removed
ATS0 Notes added
ATS7 Notes added
AT+IPR Recommendation added: To be used standalone.
AT+IPR List of bit rates detectable in autobaud mode
Fax commands Note added: Autobauding recommended when using
standard PC Fax programs
Page 8 of 204
parameters (used for AT^MONI,
29.05.2002