AT Command Set
2.15 ATL Set monitor speaker loudness
Execute command
Response
OK
ATL[val]
Reference
Note
· The two commands ATL and ATM are implemented only for V.25ter
V.25ter
compatibility reasons and have no effect.
· In multiplex mode the command is supported on logical channel 1 only.
2.16 ATM Set monitor speaker mode
Execute command
Response
OK
ATM[val]
Reference
Note
· The two commands ATL and ATM are implemented only for V.25ter
V.25ter
compatibility reasons and have no effect.
· In multiplex mode the command is supported on logical channel 1 only.
2.17 ATO Switch from command mode to data mode
Execute command
Response
ATO[n]
ATO is the corresponding command to the +++ escape sequence described in
Chapter 2.2: When you have established a data call and TA is in command mode,
ATO causes the TA to resume the data connection and return to data mode.
If connection is not successfully resumed
NO CARRIER
or
TA returns to data mode from command mode CONNECT <text>
Note:
Parameter
<n>
Reference
Note
V.25ter
TC3X_ATC_01_V04.00
<text> output only if +ATX parameter setting with value > 0.
0 switch from command mode to data mode
Page 26 of 204
29.05.2002