Advertisement
(See Figure 10 for Steps 15-21: Installing trim, covers, panels, and feet)
15. Install trim on top of front frame (presses in place).
16. Attach left side panel and handle straps (1 screw on each end), using a T25 Torx screwdriver.
17. Attach right side panel (position unit to view from front). Install screw at center of panel,
using a T15 Torx screwdriver.
18. Attach top cover using a T15 Torx screwdriver (1 screw at top of rear cover. Note that a
posidrive screw was used on earlier units).
19. Attach bottom panel (1 screw in center of panel). Panel slides in.
20. Install 4 rear feet using a T10 Torx screwdriver.
21. Place E2479A serial number label on side of rear fan assembly.
HP E2479A Upgrade Procedures
Figure 10. Installing Trim, Covers, Panels, and Feet
24
Advertisement
