Advertisement
(See Figure 6 for Steps 9-10: Installing Power Supply and Power Supply Rear Panel)
9. Connect 3-wire (5-pin) monitor cable to power supply. Install power supply by moving
power supply towards rear of unit, move board down and forward to connect pins to pin
connections on motherboard. Attach power supply (4 screws) using a T15 torx screwdriver.
10. Install power supply rear panel (3 screws located by On/Off Switch), using a T10 Torx
screwdriver.
Figure 6. Installing Power Supply and Power Supply Rear Panel
HP E2479A Upgrade Procedures
20
Advertisement
