Slot Number
Item
Input Data
IP
1.0.0.1–126.255.255.254
Address
128.1.0.1–191.254255.254
192.0.1.1–223.255.254.254
Input Data
SLOT Number
10
DTMF Behavior
Networking
Setting Up The Networking Feature
➻
84-02-35 : H.225, H.245 Information Basic Setup - Fast Start Mode
If VoIP is used for networking, the Fast Start option must be enabled.
Item
Item
No.
35
Fast Start
➻
84-05-01 : VOIPU IP Address Setup - IP Address
For each VOIPU PCB, enter the IP address for the VOIPU PCB (default: slot 1=172.16.0.20,
slot 2 = 172.16.0.21, etc). The IP address should be increased according to the number of
VOIPU PCBs. This entry becomes invalid if Program 84-04 is set to "1" (DHCP enabled).
Slot 1: 172.16.0.20
Slot 2: 172.16.0.21
Slot 3: 172.16.0.22
Slot 4: 172.16.0.23
Slot 5: 172.16.0.24
Slot 6: 172.16.0.25
Slot 7: 172.16.0.26
Slot 8: 172.16.0.27
Example:
System – A
IP Address: 172.16.0.20
Subnet Mask: 255.255.0.0
➻
84-06-10 : VOIPU Setup - DTMF Behavior
Set the DTMF option to "2" when using the networking feature. The system programming
must be exited before these program options to take affect.
0 = DTMF Relay disabled
1 = In-Band DTMF relay,
do NOT report to Host
processor
2 = Out of Band DTMF
relay, do not pass tones as
voice
Input Data
0: Disable
1: Enable
Default
Description
Set IP Address of
VoIPU PCB.
IP Address will be
increased in accor-
dance with number of
slot.
IP Address: 172.16.0.21
Subnet Mask: 255.255.0.0
0
IP Networking
Default
01-16
Related Program
84-04
This becomes invalid data
if Program 84-04 is set to
1:Enable.
System – B
01-16
•
Inbound - DTMF is transferred by
RTP packets.
•
Outbound - DTMF is transferred by
H.245 protocol.
This setting allows DTMF digits to be
relayed between the VOIPU PCBs. It is
recommended that this is set to "1".
1
◆ 27