NEC Aspire Series Networking Manual page 31

Networking
Setting Up The Networking Feature
➻
10-27 : IP System ID - IP Address
Set the System ID, IP address, and Call Procedure Port of the networked IP systems.
If setting up a multi-site network, you may wish to deÞne each system the same in this pro-
gram. This will help reduce the confusion if the same ID is programmed in each system. (You
do not need to program the IP address for the system being programmed.) Using the following
sample programming, Network 1 is ID 1, Network 2 is ID 2, Network 3 is ID 3.
System ID 1
System ID 2
System ID 3
System ID
Item
Item
No.
01 IP Address
System ID is related
with the System ID in
the Numbering Plan
(Program 11-01-01).
When the digits are
analyzed and the sys-
tem ID is determined
from the system data
set in the Numbering
Plan, the Networking
call will be sent to the
IP Address set in this
program.
The IP Address should
be the IP Address of
the peer NTCPU (Pro-
gram 10-12-01).
02 Call Procedure Port
The Port Number
should be set with the
same value as the
H.225 setup port in
Program 84-02-33.
Program 10-27-01 Entries
Network 1 Network 2
172.16.0.10 172.16.0.10
172.16.0.11 172.16.0.11
172.16.0.12 172.16.0.12
Input Data
1.0.0.1_126.255.255.254
128.1.0.1 _191.254.255.254
192.0.1.1 _223.255.254.254
1-65535
IP Networking
Network 3
172.16.0.10
172.16.0.11
172.16.0.12
01-50
Related
Default
Program
0.0.0.0 11-01-01
10-12-01
1730 84-02-33
◆ 21