Panasonic U-16GE2E5 Test Run Manual page 36

<Checking all the indoor unit addresses from an arbitrary wired remote controller>
It is possible to check the number and location of indoor units connected to the same refrigerant tubing system (with
the same system address).
In this method all the indoor units on the system are stopped.
Press the time setting
On the remote controller "System " and "Item code   " are displayed.
Using the or
Display the desired "System " (System  →  →...)
Press the button to defi ne the selected system address.
On the remote controller display "Unit No.
Press the button.
Each time the
displayed and the fan only of the selected indoor unit operates.
• Look for the indoor unit whose fan is operating. This indoor unit is the indoor unit selected on the remote
controller.
* During " " if the time setting
care is needed.
To select an address on a separate system, press the
Repeat operations
Press the button.
The remote controller returns to the normal display, and all the indoor units are stopped.
button and button simultaneously for longer than 4 seconds.
buttons select the system number.
-
button is pressed, the indoor unit No (Unit No- →-  →- ...) tubing system is
or buttons are pressed, then
- .
" (     →     →    ...).
pressed, the address will change, so
button, and it returns to "
II - 28
".