Table of Contents
Advertisement
8 - CLEANING AND MAINTENANCE
GENERAL ADVICE
•
Before you begin cleaning, you
must ensure that the appliance is
disconnected from the electrical
power supply.
•
It is advisable to clean when the
appliance is cold and especially when
cleaning the enamelled parts .
•
Avoid
leaving
substances (lemon juice, vinegar, etc .)
on the surfaces .
•
Avoid using cleaning products with a
chlorine or acidic base .
•
Important: The use of suitable
protective
recommended when handling or
cleaning of this appliance.
WARNING: When correctly installed,
your
product
requirements laid down for this type of
product category. However special care
should be taken around the rear or the
underneath of the appliance as these
areas are not designed or intended to
be touched and may contain sharp or
rough edges, that may cause injury.
STAINLESS STEEL AND ALUMINIUM
PARTS,
PAINTED
SCREEN PRINTED SURFACES
Clean using an appropriate product .
Always dry thoroughly .
IMPORTANT: these parts must be cleaned
very carefully to avoid scratching and
abrasion . You are advised to use a soft
cloth and neutral soap .
CAUTION:
Do
substances or non-neutral detergents
as these will irreparably damage the
surface.
Important: The manufacturer declines all liability for possible damage caused by
the use of unsuitable products to clean the appliance.
Attention!
The appliance gets very hot, mainly around the cooking areas. It is very important
that children are not left alone in the kitchen when you are cooking.
Do not use a steam cleaner because the moisture can get into the appliance thus
make it unsafe.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door
glass since they can scratch the surface, which may result in shattering of the
glass.
alkaline
or
acidic
clothing/gloves
meets
all
safety
AND
SILK-
not
use
abrasive
INSIDE OF OVEN
The oven should always be cleaned after
use when it has cooled down .
The cavity should be cleaned using a
mild detergent solution and warm water .
Suitable proprietary chemical cleaners
may be used after first consulting with
the manufacturers recommendations and
testing a small sample of the oven cavity .
Abrasive cleaning agents or scouring pads/
cloths should not be used on the cavity
surface .
NOTE: The manufacturers of this appliance
is
will accept no responsibility for damage
caused by chemical or abrasive cleaning .
Let the oven cool down and pay special
attention no to touch the hot heating
elements inside the oven cavity.
ENAMELLED PARTS
All the enamelled parts must be cleaned
with a sponge and soapy water or other
non-abrasive products .
Dry preferably with a microfibre or soft
cloth .
Acidic substances like lemon juice, tomato
sauce, vinegar etc . can damage the enamel
if left too long .
VITROCERAMIC COOKING HOB
– See page 15 .
27
Hide quick links:
Advertisement
Table of Contents
