Siemens SINUMERIK 840D sl Function Manual page 110

3 Setting up functions
3.2 Configuring measurements and measurement series
The following prompt is displayed if a manual axis test is not performed after
changing axis-specific parameters:
Fig. 3-18: Prompt after changing axis-specific parameters
Message
"Do you want to accept the
changes and check with an
axis test?"
"Do you want to accept the
changes and not check with
an axis test?"
"Do you want to reject the
changes?"
NOTICE
The option not to perform a manual axis test again in order to retain the "Tested"
marking despite changes to data relevant for the axis test, must be enabled in the
organizational data.
3-110
Meaning
If the axis test has already been performed
successfully, it is marked as "Tested".
If you press the "Select" softkey, "Tested" is reset and a
one-time successful execution of the axis test is
required in order to be able to also execute this
automatically (e.g. via maintenance schedules).
If the axis test has already been performed
successfully, it is marked as 'Tested'.
If you press the "Select" softkey, "Tested" is not
reset and a new axis test is not required.
Currently executed changes are rejected. If the
axis test has already been performed
successfully, it is marked as "Tested". If you press
the "Select" softkey, "Tested" is not reset and a
new axis test is not required.
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
03/2013