Huawei IN200 User Manual page 126

Huawei IN200 NIC
User Guide
Command
ethtool -N ethx
ethtool -x ethx
ethtool -X ethx
ethtool -P ethx
ethtool -l ethx
ethtool -L ethx
Some ethtool standard commands are not applicable to an IN200, and their functions are
substituted by hinicadm. For example:
l ethtool -e: provides the eeprom burning function, which is used in NIC firmware
l ethtool -d: provides the chip register dump function, which is used to collect chip
Table 6-3
For details about how to use the commands, see the help information provided on the CLI.
Table 6-3 Common ifconfig commands
Command
ifconfig ethx hw
ifconfig ethx mtu
ifconfig ethx [-]allmulti
ifconfig ethx [-]promisc
Table 6-4
details about how to use the commands, see the help information provided on the CLI.
Table 6-4 Common ip link commands
Command
ip link set dev ethx vf <num> <mac
addr>
ip link set devethx vf <num> vlan
<vlan_id> qos <vlan-qos>
Issue 06 (2019-07-27)
Function
Configures the RSS rule.
Query the indirect table.
Configures the indirect table.
Displays the fixed MAC address.
Queries the number of queues.
Configures the number of queues.
update. For an IN200, ethtool -e is substituted by the
location information. For an IN200, ethtool -d is substituted by the
command of hinicadm.
lists the common ifconfig commands supported by the IN200 and their functions.
lists the common ip link commands supported by the IN200 and their functions. For
Copyright © Huawei Technologies Co., Ltd.
Function
Configures the NIC address.
Configures the network port MTU.
Enables or disables the full multicast feature.
Enables or disables the promiscuous mode.
Function
Sets the MAC address of the virtual network port.
Sets the VLAN ID and QoS priority of the virtual
network port.
6 Management Tools
updatefw command of hinicadm.
hilink_dump
117