Using The Patient Module Start Button; Preview Plus (A.02.Xx And Higher Software Only); Using Preview Plus - HP PageWriter XL M1705B Service Manual

Using the Patient
Pressing the @ on the patient module will start recording an Auto
Module Start Button
or Manual report depending on which report format appears in the
cardiograph display window (refer to "Choosing a Report Format"
earlier in this chapter). You can halt the recording any time by
pressing the @ again. To restart the recording, press the @ a third
time.
The patient ID number appears on the patient module display when
you have already recorded an ECG. If you want to use this ID, press
the patient module start button to record the ECG; otherwise, enter
the correct patient ID at the keyboard.
Note ,I
9?
The M1702A patient module does not have a start button.
Preview Plus
(A.02.XX and Higher
Software Only)
Note .I
v
Using Preview Plus
This section contains information about the Preview Plus
application. You must have a preview screen on your cardiograph for
this application.
The Preview Plus application allows you to perform the following
tasks on your PageWriter XLi cardiograph:
H Continuously view current ECG information prior to and during
printing
H Record a patient's ECG automatically at regular intervals
n
Record delayed h/Ianual ECGs
H Reformat a stored ECG
You can also configure the PageWriter to use Preview Plus as its
power-on application. See "Power-on Application" in Chapter 2 for
more information.
To use the Preview Plus application, do the following:
1. Press Ihnenu) until the following appears in the display:
XLi Prevt SAECG
(SAECG appears only if available.)
2. Press Prevt . The following display appears:
Prev+
Reformat Timed ContPrev Delayed Exit
Operation 3-17