Testing The Components - Sony CAV-M1000ES Installation Manual

Testing the Components

It is recommended that you test all the components before
you finish with the installation of the entire system in
each zone so as not to encounter any problems after the
installation is completed. Check to see if the Main Unit,
the installed components, and the Keypad operate
properly by testing each operation.
1
Check the following connections.
- All the Keypads are connected to the Main Unit via CAT5
cables.
- An audio or a video component is connected between
AUDIO IN Left/Right and VIDEO IN of each SOURCE
connection jack.
- A display (output component) is connected to VIDEO OUT
at each ZONE connection jack.
- Speakers are connected to SPEAKERS at each ZONE
connection jack.
- An IR emitter is connected to IR OUT of each SOURCE
connection jack, and is placed near the IR sensor of the
source component.
- AC power cords for the Main Unit and the other
components are plugged in.
2
Turn on the Main Unit.
3
Select ZONE 1 by pressing the ZONE button on the
front panel of the Main Unit.
ANTENNA
R
SPEAKERS (CLASS 2 WIRING)
DVD player
IR emitter
30 US
IR OUT IR OUT IR OUT IR OUT IR OUT
VIDEO IN VIDEO OUT VIDEO IN VIDEO OUT VIDEO IN VIDEO OUT VIDEO IN VIDEO OUT VIDEO IN VIDEO OUT VIDEO IN
AUDIO IN AUDIO OUT AUDIO IN AUDIO OUT AUDIO IN AUDIO OUT AUDIO IN AUDIO OUT AUDIO IN AUDIO OUT AUDIO IN AUDIO OUT
L L L L L
R R R R R
SOURCE 1 SOURCE 2 SOURCE 3 SOURCE 4 SOURCE 5
KEYPAD KEYPAD KEYPAD KEYPAD
L R L R L R L
FIXED FIXED FIXED FIXED
VIDEO OUT VIDEO OUT VIDEO OUT
PRE OUT PRE OUT PRE OUT PRE OUT
R L R L R L R
SPEAKERS (CLASS 2 WIRING) SPEAKERS (CLASS 2 WIRING) SPEAKERS (CLASS 2 WIRING)
ZONE 1 ZONE 2 ZONE 3 ZONE 4
OUT
4
Select SOURCE 1 by pressing the SELECT SOURCE
button on the front panel of the Main Unit.
5
Turn on the Keypad in zone 1.
6
Select SOURCE 1 by pressing the SELECT button on
the Keypad. Then, check the following.
- Power control
Press POWER to turn the Keypad on or off.
- Volume adjustment
Press VOLUME +/– to adjust the volume.
- Muting
Press MUTING to mute the speaker output.
- Playback operation
Press the Play, Stop, Pause, and ./> buttons on the
Keypad to confirm that the source component operates
properly.
- Remote control operation
Check that the remote control of the SOURCE 1 component
works by pressing any command button while pointing
the Remote Control toward the IR sensor of the Keypad.
Then check that the SOURCE 1 component operates
properly using the remote control.
7
Perform the test in each zone from zone 1 through
zone 6 by repeating Steps 3 to 6.
IR OUT IR OUT IR OUT IR OUT
COMMON
12V TRIGGER
1 2 3
VIDEO OUT VIDEO IN VIDEO OUT VIDEO IN VIDEO OUT
AUDIO IN AUDIO OUT AUDIO IN AUDIO OUT
L L L
CONTROL
A1 II 4 5 6
R R R
SOURCE 6 SOURCE 7 SOURCE 8
KEYPAD KEYPAD
R L R L
VARIABLE VARIABLE
VIDEO OUT VIDEO OUT VIDEO OUT
PRE OUT PRE OUT
L R L R L
SPEAKERS IMPEDANCE
SPEAKERS (CLASS 2 WIRING) SPEAKERS (CLASS 2 WIRING)
USE 4- 16
ZONE 5 ZONE 6
TO SPEAKERS FROM AMPLIFIER
R L R L
IN
MODE
IR IN
SUB MAIN
Keypad
~AC IN
STR
DVP
AUX
RS232C
SP TV SP