Brother BAS H Series Instruction Manual page 83

2 ） When inserting a straight line after a selected component point
* The above operation is only enabled for straight lines, curves and arcs.
[Before inserting straight line]
1. Touch .
2. Use to move the cursor
* You can move the cursor continuously by holding
down the key.
3. Touch .
4. Touch .
[After inserting straight line]
#4 →
5. Touch
6. Use the jog key to move the cursor to the position
to #2.
where you would like to insert the pattern.
7. Press
8. Use the jog key to move the cursor
point.
9. Press
BAS H series, Programmer
CHAPTER 3 PROGRAMMING PATTERNS
#3 →
to select "Insert".
to provisionally set the start point.
to confirm the pattern.
to the end
75