CHAPTER 3 PROGRAMMING PATTERNS
*4 This can only be set when the line type is set to "V Zigzag" or "N Zigzag".
*5 This can only be set when backtack start mode (backtack end mode) is set to a setting other than "No back Tack".
*6 This can only be set when drawing a rectangle, circle (radius), circle (diameter), circle (3 points) or ellipse.
*7 This can only be set when creating needle drop data.
*8 This can only be set when creating feed data or basting data.
■
Parameter setting examples
Example 1: To create sewing points which are as even as possible without exceeding the specified pitch: Set the
running generation mode to "Equal Pitch".
Example 2: To connect the end point of the previous outline and the start point of the current outline by feeding:
Set the outline connection to "Feed".
28
BAS H series, Programmer