Accessing The Internal Components Of The Computer - HP Media Card Reader with PCI Card Installation Manual

Accessing the Internal Components of the
Computer
CAUTION: Static electricity can damage the electronic components of the
Ä
computer or the HP Media Card Reader and PCI card. Before beginning
these procedures, ensure that you are discharged of static electricity by
briefly touching a grounded metal object. Refer to the documentation
included with your computer for additional information on preventing
electrostatic discharge.
CAUTION: When the computer is plugged into an AC power source,
Ä
voltage is always applied to the system board. You must disconnect the
power cord from the power source before opening the computer to prevent
system board damage.
WARNING: To reduce the risk of personal injury from electrical shock
Å
and/or hot surfaces, be sure to disconnect the power cord on the computer
from the wall outlet and allow the internal system components to cool
before touching.
To prepare the computer for installation of the HP Media Card
Reader with PCI card, refer to the documentation included with
your computer for detailed instructions to:
1. Power off and unplug the computer from the power source.
2. Remove the computer cover or access panel.
3. Remove the front bezel.
4. Remove the 3.5-inch or 5.25-inch bezel blank (or remove the
3.5-inch or 5.25-inch drive if you are replacing a drive with
the HP Media Card Reader and do not have an empty drive
bay).
Installation Guide
HP Media Card Reader with PCI Card
www.hp.com 3