Preparing The Computer; Accessing The Internal Components Of The Computer; Removing Components - HP Z400 - Workstation Installation Manual

f.

Preparing the computer

NOTE: Computer models vary. All illustrations are examples only.

Accessing the internal components of the computer

1. If you need help preparing the computer for this installation, consult the removal and
replacement procedures in the service guide for your computer at
manuals.
2. Power down the computer, and then disconnect the power cord.
3. Power down all external devices, and then disconnect them from the computer.
4. Remove the side access panel.

Removing components

1. If present, remove the card support to access the system board connectors.
2. If present, remove the airflow guide to access the optical bays.
3. Remove the front bezel, if required to install a device in the optical bay.
NOTE:
and Z800 Workstations.
4. Remove the bezel blank cover or filler tray from the optical drive bay (or remove the drive from
the bay if you are replacing an existing drive with the media card reader and do not have an
empty drive bay).
4 HP 22-in-1 Media Card Reader
The green carrier latch (5) snaps into place when fully seated.
Figure 3 Installing the media reader in the bay adapter
The front bezel does not need to be removed to install the media reader in HP Z600
http://www.hp.com/support/
ENWW