Connecting To A Pid - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual
----End
Follow-up Procedure
Take operations in reversed order to disconnect the SmartLogger from the PC.

4.9 Connecting to a PID

This section describes how to connect the SmartLogger to a PID.
Context
There are three RS485 ports in the SmartLogger. For the port descriptions, see Context in
4.4.1 Connecting the SmartLogger to the
Figure 4-30
Figure 4-30 Connecting the SmartLogger to the PID
Procedure
Step 1 Connect one end of the cable delivered with the PID to the RS485 port of the PID.
Step 2 Connect the other end of the cable to a Surge port of the RS485 signal SPD. For details, see
Step 2–Step 4
Issue 12 (2019-01-15)
 To enable communication between the SmartLogger and the NMS on the PC, set the management
system parameters properly on the LCD or WebUI. For details, see
Parameters or 7.10.2.4 Setting Management System
shows how to connect the SmartLogger to the PID module.
In the scenarios with the communication box, the SmartLogger and PID module are installed before
delivery, and the PID module is connected to the SmartLogger through the X2 terminal block.
in Procedure in
Copyright © Huawei Technologies Co., Ltd.
Parameters.
SUN2000.
4.4.1 Connecting the SmartLogger to the
4 Electrical Connections
6.2.26 Setting Communications
SUN2000.
50