Manually Powering On Or Off The Pid On The Monitoring Panel - Huawei SmartLogger1000 User Manual

SmartLogger1000
User Manual
No. Parameter
Name
8 Maximum
output
voltage
9 IMD access
10 Periodic
PID runtime
11 Periodic
IMD
runtime
12 IMD control
dry contact
6.2.16 Manually Powering On or Off the PID on the monitoring
panel
This topic describes how to power on or off the PID on the monitoring panel.
Procedure

Issue 12 (2019-01-15)
Function Parameter
Value
Specifies the 0–500 V
maximum output
voltage of the
PID module
when Operation
Mode is set to
Normal or
Commissioning.
Specifies whether Enable
the PID module
and insulation
monitor device
(IMD) can
operate in cycle
mode.
Disable
Specifies the 60–480 min
operating time
segment of the
PID module
when the PID
module and IMD
operate in cycle
mode.
Specifies the 15–480 min
operating time
segment of the
IMD when the
PID module and
IMD operate in
cycle mode.
Dry contact No. DO1, DO2,
over which the and DO3
SmartLogger
controls the IMD
The following table shows the procedure for powering on or off the PID on the
monitoring panel. The parameter values in the following figures are for reference only.
Copyright © Huawei Technologies Co., Ltd.
Description
If the compensation mode is PV/PE, the parameter
value indicates the highest DC output voltage
between PV and PE; if the compensation mode is
N/PE, the parameter value indicates the highest DC
output voltage between N and PE.
Select Enable if you allow the PID module and
IMD to operate in cycle mode.
Only the IMDs of mainstream suppliers such as
DOLD and BENDER are supported, and the IMDs
must have enabled dry contacts.
Select Disable if you forbid the access of IMDs.
The IMD device is shut down when the PID module
is operating.
The PID module is standby when the IMD device is
operating.
Set appropriate ports based on the cable connections
between the IMD and the SmartLogger.
6 User Interface
96