Adjustment - Kenwood TK-5810 Service Manual

TK-5810 BG
(
Controls
• KCH-14 (Basic control panel)
Power
switch
POWER
GRP
TX BUSY
VOL
MIC jack Volume Selector
• KCH-15 (Full-featured control panel)
Power
switch
POWER
CALL
GRP
TX BUSY
VOL
MIC jack Volume Selector
Panel Test Mode
■ Test mode operation features
This transceiver has a test mode. To enter test mode,
press and hold the [PF1] key while turning the transceiver
power ON. Test mode can be inhibited by programming. To
exit test mode, turn the transceiver power OFF.
• When the panel test mode is activated, the last used
channel and signaling numbers are displayed. When the
panel test mode is activated for the fi rst time, the chan-
nel and signaling numbers are 1.
• If test signaling 26 (Tone Pattern) is selected, the result
of Bit Error Rate (BER) calculation is displayed on the
LCD. The BER value is also output from the serial port.
56
/5810H BG
) ( )

ADJUSTMENT

CH
PF1 PF2 PF3 PF4
key key key key
MON
MON SCAN SP OPT A B C OST
SCN
CH
PF1 PF2 PF3 PF4
key key key key
■ Key operation
Key
[Selector] Wide/Narrow/P25
Shifts to the Panel tuning
[GRP ]
mode
[GRP ] High Power/Low Power
[GRP ]
Squelch off
Hold
PF5
[PF1] Test frequency channel down Channel No.
key
Test frequency channel
[PF1] Hold
continuation down
[PF2] Test frequency channel up
Test frequency channel
[PF2] Hold
continuation up
[PF3] Test signaling down
Test signaling continuation
[PF3] Hold
down
[PF4] Test signaling up
[PF4] Hold Test signaling continuation up Signaling No.
[PF5] Function on
PF5
MIC PTT Transmit
key
MIC Use as the DTMF keypad.
keypad If a key is pressed during
([0] to [9] transmission, the DTMF
and corresponding to the key
[#], [ ]) that was presses is sent.
Key
[Selector] Function off
[GRP ] Squelch level 0
[GRP ] AFC on/off
[PF1] Compander on/off
[PF2] LCD all lights
[PF3] MSK 1200bps/2400bps
[PF4] Beat shift on/off
[PF5] Function off
MIC PTT Transmit
MIC
keypad
([0] to [9] Function off
and
[#], [ ])
"FNC" not appears
Function Display
Wide: "W" appears
Narrow: "N" appears
P25: "A" appears
−
High: "SP" icon disappears
Low: "SP" icon appears
"MON" icon appears
Channel No.
Channel No.
Channel No.
Signaling No.
Signaling No.
Signaling No.
"FNC" appears
−
−
"FNC" appears
Function Display
−
On: "▼" icon appears
On: "OP" icon appears
The "OP" icon is displayed
only when Test Signaling
has been set to 17~19 or
21~26.
On: "A" icon appears
LCD all point appears
2400bps: "CALL" icon ap-
pears
On: "OS" icon appears
(KCH-14)
On: "OST" icon appears
(KCH-15)
−
−
−