Siemens SINUMERIK FM-NC Installation And Startup Manual page 201

12.98
03.96
1
IS "Spindle
in setpoint range"
(DB31–48,
DBX83.5)?
Change over
gear stage
yes
All gear
no
stages tested?
yes
Position
spindle?
yes
Position
reached from
high speed and
zero speed?
Change over
gear stage
yes
All gear
no
stages
tested?
End
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
Check machine data and interface signals
MD 35110–35140
no
MD 35150
IS "Actual gear stage" (DB31–48, DBB16)
IS "Select drive parameter set" (DB31–48, DBB21)
IS "Setpoint gear stage" (DB31–48, DBB82)
IS "Active drive parameter set" (DB31–48, DBB93)
no
End
Check machine data
MD 36000
no
MD 36010
MD 32200
MD 35210
MD 35300
MD 36300
Check encoder matching
Check spindle synchronization (MD 34200)
yes
9 Axis and Spindle Dry Run
9.3 Testing the spindle
Speeds for gear stages
Spindle speed tolerance
Coarse exact stop
Fine exact stop
K factor
V
Acceleration in position control range
Creep speed
Encoder limit frequency
9
J
9-201