Siemens SINUMERIK FM-NC Installation And Startup Manual page 109

03.96
Example for milling machine: MD 10000
AXCONF_MACHAX_NAME_TAB[0] = X1
AXCONF_MACHAX_NAME_TAB[1] = Y1
AXCONF_MACHAX_NAME_TAB[2] = Z1
AXCONF_MACHAX_NAME_TAB[3] = A1
AXCONF_MACHAX_NAME_TAB[4] = C1
2. Channel level
S
S
3. Program level
S
S
Note the relationship with the inclusion of tool offsets in the calculation (G17,
G18, G19).
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
6 Assigning Parameters to the Control and the PLC Program
MD 20070: AXCONF_MACHAX_USED[0...7]
The machine axes are assigned to a geometry channel with the channel-
specific MD.
Turning machine
1 2 3
MD 20080: AXCONF_CHANAX_NAME_TAB[0...7]
This MD defines the names of the axes in the channel. Enter the
names of the geometry and auxiliary axes here.
X Z C
MD 20060: AXCONF_GEOAX_NAME_TAB[0...2]
This MD specifies the names to be used in the part programs for the geome-
try axes (workpiece axes not specific to machine).
X Y* Z
* In a transformation e.g. TRANSMIT
the 2nd geometry axis coordinate
must also be assigned a name (e.g. "Y")
MD 20050: AXCONF_GEOAX_ASSIGN_TAB[0...2]
Defines the assignment between the geometry axes and the channel axes
(MD20070) without transformation. (For assignment with an active trans-
formation, please refer to: References: /FB/, K2.)
1 0 2
6.9 Axes and spindles
Milling machine
0 0 1 2
X Y
X Y
1 2
3 4 5
Z A C
Z
3
6-109
6