Items Relating To The Video Control (Nos. 706 To; Items Relating To The Video Control (Nos. 706 To - Sony 5500 Operation Manual

Item number Item
628 REMAIN TIME
DISPLAY
630 TC CONVERT
631 ORIGINAL TC
display
632 JUMPING TC
select

Items Relating to the Video Control (Nos. 706 to ...)

Item number Item
706 FORCED
VERTICAL
INTERPOLATION
OFF
707 ROUNDING
(SRW-5500 only)
1) A-ROUNDING™
A method for rounding a 10 bit signal to 8 bits. This process suppresses
step noise that occurs when lines which differ slightly from the horizontal
are displayed.
A-ROUNDING is a trademark of Sony Corporation.
158
Menu List
Setting Function
[off] Sets whether to display remaining time on the tape in
10min superimposed character position.
on off: Do not display remaining time.
10min: Display remaining time when it is 10 minutes or
on: Always display remaining time.
Note
The remaining time on the tape is not displayed when no
cassette is inserted. The remaining time is not also
displayed until the VTR finishes detecting the diameter of
the wound tape and estimating the remaining time
immediately after the cassette is inserted.
[off] Selects whether to convert the playback time code to the
on operating frequency time code when tapes recorded with
different frame rates are used for off-speed playback.
off: Does not convert the time code.
on: Converts the time code.
[off]
When item 630 is set to "on," this setting specifies whether
on the 24-frame time code is displayed or not on the control
panel of the VTR before conversion.
off: The 24-frame time code is not displayed before
on: The 24-frame time code is displayed before conversion.
Sets the loopback point (JUMPING TC) for converting time
−
[ 3H]
code with respect to the reference time code (STARTING
–2H
TC) for conversion.
–1H
–3H: The JUMPING TC is set 3 hours before STARTING
+1H
+2H
–2H: The JUMPING TC is set 2 hours before STARTING
+3H
0H
–1H: The JUMPING TC is set 1 hour before STARTING TC.
+1H: The JUMPING TC is set 1 hour after STARTING TC.
+2H: The JUMPING TC is set 2 hours after STARTING TC.
+3H: The JUMPING TC is set 3 hours after STARTING TC.
0H: The JUMPING TC is set 1 frame before STARTING TC.
Setting Function
[auto]
Specifies whether or not Y-add operation mode is
forced YADD off automatically turned on during DT playback.
auto: Y-add operation mode is automatically turned on.
forced YADD off: Y-add operation mode is off all the time.
[simple]
Selects whether to perform A-ROUNDING
adaptive
simple: Do not perform A-ROUNDING
adaptive: Perform A-ROUNDING
less.
conversion.
The type of time code displayed is specified by item
603.
TC.
TC.
input signals are simply rounded to 8 bits.
TM
input signals are adaptively rounded to 8 bits.
TM 1)
processing.
TM
processing. 10-bit
processing. 10-bit