The Erase Button; The Status Indicator; Ventilation - GE CRxVision Operating Manual

The Erase Button

Press the erase button
After pressing the erase button, the status indicator is continuously lighting up in blue and the
CRxVision starts erasing the next inserted image plate. If no image plate has been inserted
after 60 seconds, the system automatically returns to standby mode.

The Status Indicator

Status CRxVision Status
Indicator
Ready for erasure
Constant
blue
Blue Erasure ongoing
blinking
Constant Ready for scanning
green
Green Busy
blinking
Constant Fatal CRxVision error or
red
Service mode active (e.g.
shading calibration)
Slow red Boot-up or
blinking
Stand by mode or
( 1 / sec.)
CRxVision warning or
non fatal error
Fast red No connection to the
blinking Digitizer Remote Display
( 3 / sec.)
Triple No network connection
blinking
( 3 / sec. +
1 sec. off)

Ventilation

The digitizer has a ventilation opening in the rear cover (1) and in the left cover (2).
The ventilation openings may not be covered.
1
14
to start the erasing cycle of an image plate.
Meaning
The CRxVision will erase the next image plate.
The CRxVision is erasing an image plate.
The CRxVision is ready for scanning the next image plate.
The CRxVision is scanning an image plate.
Scanning is not possible due to:

Service intervention is required or

Service function which blocks scanning is called up by the field
service engineer.
Scanning is not possible due to:

User has to wait until boot-up is finished or

User has to initiate the scanning or erasing of an image plate
or

User intervention is required to continue. See message
displayed in the Digitizer Remote Display.
Scanning is not possible as the Digitizer Remote Display on the
workstation is not up-to-date or not started up.
Scanning is not possible as the Network connectivity test of the
CRxVision to the workstation failed.
2
CRxVision Operating Manual V1.2