ShopTurn Functions
5
5.6 Contour milling
End face Y:
CP
Reference point
Z0
Reference point in Z direction (abs.)
Z1
Depth with reference to Z0 (abs. or inc.)
DZ
Maximum depth infeed (Z direction)
UXY
Finishing allowance in plane
Peripheral surface Y:
C0
Reference point
X0
Reference point in X direction (abs.)
X1
Depth with reference to X0 (abs. or inc.)
DX
Maximum depth infeed (X direction)
UYZ
Finishing allowance in plane
Retraction
If more than one approach point is necessary, specify the retraction height to which
mode
the tool retracts between approach points.
If there are no spigots or other elements in the machining range higher than Z0 (X0),
Z0 + safety clearance (X0 + safety clearance) can be programmed as the retraction
mode.
5.6.14 Chamfering a contour spigot
Spigot
milling
Parameters
T, D, F, S, V
See Sec. "Creating program blocks".
Position
Select from 8 different positions:
Clamp/release spindle (for End face Y/Peripheral surface Y only)
The function must be set up by the machine manufacturer.
5-310
To retraction plane
Z0+safety clearance (for end face/end face C and end face Y only) or
X0+safety clearance (for peripheral surface/peripheral surface C and peripheral
surface Y only)
If you have planned edge breaking, mill a chamfer after that.
Press the "Milling", "Contour milling" and "Spigot milling" soft keys.
Contour
milling
>
Select "Chamfer" machining mode.
Description of finishing the edge
End face/End face C – Front
End face/End face C – Rear
Peripheral surface/Peripheral surface C – Inner
Peripheral surface/Peripheral surface C – Outer
End face Y – Front (only when Y axis exists)
End face Y – Rear (only when Y axis exists)
Peripheral surface Y – inner (only when Y axis exists)
Peripheral surface Y – Rear (only when Y axis exists)
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
08/2005
5
Degrees
mm
mm
mm
mm
Degrees
mm
mm
mm
mm
♥ Siemens AG, 2005. All rights reserved