Bosch XDK110 General Information Manual page 48

!
4.2.4 Mechanical design of extension boards
The extension bus connector of XDK is a 26-pin male connector of type
your extension boards, please use the same connector and use the flat ribbon cable to connect
your extension board to XDK.
Certification Limits
XDK certification does not apply to extension boards other than the "XDK gateway". If you use your
own hardware connected to XDK, you need to check the compliance to legal standards according
to your region. Customer-made extension boards are not supported by BCDS and any damage to
the XDK caused by connecting improper hardware to XDK will void the warranty.
The MCU pins refer to the Giant Gecko microcontroller on the XDK. For details on the
configuration, please refer to the
4.2.5 Errata
Unfortunately there is an error in the labeling of the "XDK Gateway" (Version V1.0) extension board
delivered with XDK. Some of the pin names were swapped. The correct pin assignment is shown
in the picture below. We apologize for any inconvenience caused by this.
Picture 23: XDK Gateway
XDK110
© Bosch Connected Devices and Solutions GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such as
copying and passing on to third parties. BOSCH and the symbol are registered trademarks of Robert Bosch GmbH, Germany.
Note: Specifications within this document are subject to change without notice.
General Information Guide XDK110
MCU datasheet
#
and MCU Reference Manual.
Page ! 4 8
ERNI Male 054595. For
BCDS