Information To The Installer - Siemens Sinorix al-deco STD Operating Handbook

What happens when there's a fire?
Warning!
Once the extinguisher system has been activated, no second fire will be able to be extinguished
in the same machine tool until the extinguisher system has been serviced again. This servicing
may only be carried out by Siemens or by one of the partners authorised by Siemens.
You can only remove the key if the system has been serviced, and the pressure switch can only be
returned to its initial position when the extinguisher container is full again (see Maintenance and
Repair Instructions). Only then is the communication interface reset.
5.4

Information to the installer

Following an initiation or fault on the extinguisher system, you, as the operator, must immediately
inform the installer (see Maintenance and Repair Instructions).
24
Building Technologies
Fire Safety
A54475-A1-A2_EN_05.docx
01.2018