Connecting A Power Cable - Huawei 5288 V3 V100R003 User Manual

5288 V3 Server
User Guide
Figure 3-27 Connecting a serial cable
Do not use excessive force; otherwise, the pins in the serial port may be damaged.
Step 2 Tighten the screws on the connector to secure the serial cable.
----End

3.5.6 Connecting a Power Cable

The following describes how to connect AC and DC power cables. Connect AC or DC power
cables based on the PSU type.
Before connecting power cables, ensure that the server and its internal components have been
installed, and the PGND cable is connected to server (For the 5288 V3, which does not
provide ground terminals, connect the PGND cable to the cabinet where the server is located).
Use dedicated power cables to ensure equipment and personal safety. Power cables must be
securely connected. Power cables are used only for dedicated servers. Do not use them for
other devices.
The following tools are available:
ESD wrist strap or ESD gloves: used to prevent ESD damage
Connecting an AC Power Cable
Step 1 Wear an ESD wrist strap.
Step 2 Connect one end of the AC power cable to the power port on the PSU of the server.
l
Issue 26 (2018-11-19)
If the PSU has a velcro strap, use the velcro strap to bind the power cable to the middle
of the PSU handle after connecting the power cable to the PSU to prevent power cable
poor contact or disconnection. See
the PSU using a velcro
Copyright © Huawei Technologies Co., Ltd.
Figure1 Connecting a power cable (secured with
strap).
3 Installing and Removing the 5288 V3
77